Basic Info.
Packaging & Delivery
Product Description
Product introduction Microwave motion switch is a new technology of motion switch, more sensitive than PIR infrared motion switch and adjustable, appearance is concise and easy, powerful, deeply the general customers' preferences, are the essentials of intelligent household life.
G3MS is an active motion detector with adjustable sensitivity, daylight detection and time setting. It's based Doppler principle and RADAR technology, adopting rod antenna & high performance micro-chip. It is easy to install, provide. high probability of detection, low nuisance alarms and resistance to rain, fog, wind, dust, falling snow and temperature extremes
Feature
Recommend this product installed on the ceiling.
Based Doppler principle and radar technology, adopting rod antenna & high performance micro-chip.
It can adjust sensitivity, daylight detection and time according to your requirements.
360°detection range and 8m max detection distance.
Easy to install, provide high probability of detection, low nuisance alarms and resistance to rain, fog, wind, dust, falling snow and temperature extremes.
Technical parameters
| Operating voltage | 220-240V/AC |
| Rated load | 400W(Max. inductive Load)/800W (Max. Resistive load) |
| Detection area | 2-10 meters |
| Time setting | 10sec-12min |
| Light control | 2~2000lux, can be customized |
| Microware frequency | 5.8GHz +/-75MHz |
| Transmission power | <0.2mW |
| Installation | Ceiling mounting |
| Detection angle | 360° |
| Mounting height Max. | 5 m |
| Operating temperature | -10°C~+60°C |
| Product size(L*W*H) | 95*95*43mm |
Note: the high-frequency output of this sensor is <0.2mW that is just one of the transmission power of a mobile
phone
Installation procedure
3.1 Take down the top cover by turning it anti-clockwise(see fig.1),
3.2 Hold base against the wall and mark drill holes, paying attention to any existing wiring in the wall
3.3 Drill the holes, insert wall plug( 6mm dia.)
3.4 Put the power wire and load wire through the base holes
3.5 Screw the base into place (see fig.2)
3.6 Connect the mains power supply and the load wire to the connection terminal according to connection-wire mark
3.7 Fit glass shad and turn it clockwise(see fig.2)
